Power Specifications - Cisco SNS 3515 Manual

Install Cisco ISE Software on the SNS 3515 and SNS 3595 Appliances

Power Specifications

The power specifications for the power supply options are listed in the following section:
Do not mix power supply types in the server. Both power supplies must be identical.
Note
770-WAC Power Supply
Description
AC input voltage range
AC input frequency
AC line input current (steady state)
Maximum output power for each power supply
Power supply output voltage
Install the Cisco SNS 3515 and Cisco SNS 3595 Hardware
Appliances
This section describes how to install your Cisco SNS 3515 or 3595 appliance and connect it to the network.
It contains:
•
•
•
•
Before you begin the installation, read the
3515 or Cisco SNS 3595 Hardware
Warning: Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Warning: This unit is intended for installation in restricted access areas. A restricted access area can be accessed
only through the use of a special tool, lock and key, or other means of security.
Install the Cisco SNS 3515 or 3595 Appliance in a Rack, on page 16
Cisco Integrated Management Controller, on page 27
Connect Cables, on page 21
Connect and Power On the Cisco SNS 3515 or 3595 Appliance, on page 25
Install the Cisco SNS 3515 and Cisco SNS 3595 Hardware Appliances
Specification
90 to 264 VAC (self-ranging, 100 to 264 VAC
nominal)
Range: 47 to 63 Hz (single phase, 50 to 60 Hz
nominal)
9.5 A peak at 100 VAC
4.5 A peak at 208 VAC
770 W
Main power: 12 VDC
Standby power: 12 VDC
Regulatory Compliance and Safety Information for the Cisco SNS
Appliance.
Cisco Identity Services Engine Hardware Installation Guide, Release 2.0.1
15