Regulatory Compliance; Before You Begin; Safety Guidelines - Cisco SNS 3515 Manual

Before You Begin

Regulatory Compliance

For regulatory compliance and safety information, see
Cisco SNS-3415 and Cisco SNS-3495
Before You Begin
This section provides information on how you can prepare your site for safely installing the Cisco SNS-3515
or Cisco SNS-3595 appliance.

Safety Guidelines

Note Before you install, operate, or service a Cisco SNS-3515 or Cisco SNS-3595 appliance, review the
Regulatory Compliance and Safety Information for Cisco SNS-3515 and Cisco SNS-3595 Appliances
important safety information.
Warning: IMPORTANT SAFETY INSTRUCTIONS
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you work
on any equipment, be aware of the hazards involved with electrical circuitry and be familiar with standard
practices for preventing accidents. Use the statement number provided at the end of each warning to locate
its translation in the translated safety warnings that accompanied this device.
Statement 1071
Warning: To prevent the system from overheating, do not operate it in an area that exceeds the maximum
recommended ambient temperature of: 40° C (104° F).
Statement 1047
Warning: The plug-socket combination must be accessible at all times, because it serves as the main
disconnecting device.
Statement 1019
This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure that the
protective device is rated not greater than: 250 V, 15 A.
Statement 1005
Installation of the equipment must comply with local and national electrical codes.
Statement 1074
When you are installing a server, use the following guidelines
• Plan your site configuration and prepare the site before installing the server. See the
• Ensure that there is adequate space around the server to allow for servicing the server and for adequate
Cisco Identity Services Engine Hardware Installation Guide, Release 2.0.1
10
Preparation Guide for the recommended site planning tasks.
airflow. The airflow in this server is from front to back.
Install Cisco ISE Software on the SNS 3515 and SNS 3595 Appliances
Regulatory Compliance and Safety Information for
Appliances.
for
Cisco UCS Site