Server Specifications; Rack Requirements; Equipment Requirements; Slide Rail Adjustment Range - Cisco SNS 3515 Manual

Install Cisco ISE Software on the SNS 3515 and SNS 3595 Appliances
Statement 1074
Caution Avoid UPS types that use ferroresonant technology. These UPS types can become unstable with systems
such as the Cisco UCS, which can have substantial current draw fluctuations from fluctuating data traffic
patterns.
When you are installing a server, use the following guidelines
• Plan your site configuration and prepare the site before installing the server. See the
• Ensure that there is adequate space around the server to allow for servicing the server and for adequate
• Ensure that the air-conditioning meets the thermal requirements listed in the
• Ensure that the cabinet or rack meets the requirements listed in the
• Ensure that the site power meets the power requirements listed in the

Rack Requirements

This section provides the requirements for the standard open racks.
The rack must be of the following type:
• A standard 19-in. (48.3-cm) wide, four-post EIA rack, with mounting posts that conform to English
• The rack post holes can be square 0.38-inch (9.6 mm), round 0.28-inch (7.1 mm), #12-24 UNC, or
• The minimum vertical rack space per server must be one RU, equal to 1.75 in. (44.45 mm).

Equipment Requirements

The slide rails supplied by Cisco Systems for this server do not require tools for installation. The inner rails
(mounting brackets) are pre-attached to the sides of the server.

Slide Rail Adjustment Range

The slide rails for this server have an adjustment range of 24 to 36 inches (610 to 914 mm).

Server Specifications

This section lists the technical specifications for the server and includes the following sections:
Preparation Guide for the recommended site planning tasks.
airflow. The airflow in this server is from front to back.
page 13.
15. If available, you can use an uninterruptible power supply (UPS) to protect against power failures.
universal hole spacing, per section 1 of ANSI/EIA-310-D-1992.
#10-32 UNC when you use the supplied slide rails.
Cisco Identity Services Engine Hardware Installation Guide, Release 2.0.1
Server Specifications
Cisco UCS Site
Server Specifications, on
Rack Requirements, on page
Power Specifications, on page
13.
13