Tektronix DG2020A Programmer's Manual page 123

STARt
Group
Related Commands
Syntax
Arguments
Examples
*STB?
Group
Related Commands
Syntax
Arguments
Responses
Examples
DG2020A Programmer Manual
The STARt command sets the instrument to the start state. If the run mode is set
to repeat or step, pattern data or sequence output starts. If the run mode is set to
single, then the instrument goes to the trigger wait state.
MODE
RUNNing?, STOP, *TRG
STARt
None
:START
sets the instrument to the start state.
The *STB? common query returns the value of the SBR (Status Byte Register).
Bit 6 of the SBR is read as a MSS (Master Status Summary) bit. Refer to Section
3 Status and Events, for more details on the SBR.
STATUS & EVENT
*CLS, DESE, *ESE, *ESR, EVENT?, EVMsg?, EVQty?, *SRE
*STB?
None
<NR1>
which is a decimal number.
*STB?
might return 96, which indicates that the SBR contains the binary number
01100000.
Command Descriptions
2 101