Electrical; 220V Operation; Extension Cords; Electrical Specifications - Shop fox M1112 Owner's Manual

M1112 12" x 36" Gunsmithing Lathe
The machine must be properly set up before it is
safe to operate. DO NOT connect this machine to the
power source until instructed to do so in the "Test
Run" portion of this manual.

220V Operation

The Model M1112 is wired for 220V single-phase operation.
We recommend connecting this machine to a dedicated
circuit with a verified ground, using the circuit size given
below. Never replace a circuit breaker with one of higher
amperage without consulting a qualified electrician to
ensure compliance with wiring codes. This machine must
be connected to a grounded circuit!
A plug is not supplied with this machine. See below for
the recommended plug type for this machine.
If you are unsure about the wiring codes in your area
or you plan to connect your machine to a shared cir-
cuit, you may create a fire or circuit overload hazard—
consult a qualified electrician to reduce this risk.

Extension Cords

We do not recommend using an extension cord; however,
if you have no alternative, use the following guidelines:
• Use a cord rated for Standard Service (S).
• Do not use an extension cord longer than 50 feet.
• Ensure that the cord has a ground wire and pin.
• Use the gauge size listed below as a minimum.

Electrical Specifications

Operating Voltage
220V Operation

ELECTRICAL

Amp Draw Min. Circuit Size
10 Amps
6-15P
Figure 6. 6-15 plug and receptacle.
DO NOT work on your electrical system
if you are unsure about electrical
codes and wiring! Seek assistance from
a qualified electrician. Ignoring this
warning can cause electrocution, fire,
or machine damage.
Recommended Plug
15A NEMA 6-15 (not incl.)
-11-
6-15R
Extension Cord
14 Gauge