Front Panel Components - D-Link DGS-3000 series Hardware Installation Manual

Front Panel Components

The front panel of the Switch features a variety of ports and LED indicators that will be discussed in detail in this
section. Also located on the front panel of the Switch is a pinhole that can be pressed and held for 5 seconds to
perform a hardware factory reset on the Switch after which the Switch will reboot. This will clear all the software
modifications done on the Switch to their factory default settings. Zero Touch Provisioning (ZTP) will be supported in
the next ME Series release.
DGS-3000 Series Gigabit Ethernet Switch Hardware Installation Guide
Figure 1-1 Front panel view of a DGS-3000-10L Switch
Figure 1-2 Front panel view of a DGS-3000-20L Switch
Figure 1-3 Front panel view of a DGS-3000-28L Switch
Figure 1-4 Front panel view of a DGS-3000-28LP Switch
Figure 1-5 Front panel view of a DGS-3000-28X Switch
Figure 1-6 Front panel view of a DGS-3000-28XMP Switch
Figure 1-7 Front panel view of a DGS-3000-28XS Switch
8