Operation; Packaging, Transport And Storage - Vega VEGABAR 14 Operating Instructions Manual

3 Product description
Functional principle
Voltage supply
Packaging
Transport
Transport inspection
Storage
Storage and transport
temperature
8
The sensor element is the CERTEC
ceramic diaphragm. The process pressure causes a capacitance
change in the measuring cell via the ceramic diaphragm. This change
is converted into an appropriate output signal and outputted as
measured value.
Two-wire electronics 4 ... 20 mA for power supply and measured
value transmission over the same cable.

3.3 Operation

The instrument offers no adjustment options.

3.4 Packaging, transport and storage

The device was protected by packaging during transport. Its capacity
to handle normal loads during transport is assured by a test according
to DIN EN 24180.
The packaging of standard instruments consists of environment-
friendly, recyclable cardboard. For special versions, PE foam or PE foil
is also used. Dispose of the packaging material via specialised
recycling companies.
Transport must be carried out under consideration of the notes on the
transport packaging. Nonobservance of these instructions can cause
damage to the device.
The delivery must be checked for completeness and possible transit
damage immediately at receipt. Ascertained transit damage or
concealed defects must be appropriately dealt with.
Up to the time of installation, the packages must be left closed and
stored according to the orientation and storage markings on the
outside.
Unless otherwise indicated, the packages must be stored only under
the following conditions:
Not in the open
l
Dry and dust free
l
Not exposed to corrosive media
l
Protected against solar radiation
l
Avoiding mechanical shock and vibration
l
Storage and transport temperature see chapter "Supplement -
l
Technical data - Ambient conditions"
Relative humidity 20 ... 85 %
l
®
measuring cell with rugged
VEGABAR 14