Table of Contents
Advertisement
Injection
Specific tooling
AP8140595 Axone + battery charger (230V 50Hz)
AP8202311 Axone + battery charger (110V 60Hz)
Make sure that the throttle valve control is in con-
tact with the stop screw.
Guaranteeing that this position will be kept, give the confirmation for the TPS reset procedure.
Reset should be performed in the following cases:
- on first fitting.
- if the injection control unit is replaced.
NOTE
THE TPS RESETTING PROCEDURE MUST NOT BE CARRIED OUT WITH A USED THROTTLE
BODY BECAUSE POSSIBLE VALVE WEAR AND STOP WEAR FOR THE MINIMUM OPENING
MAKE THE AIR FLOW DIFFERENT FROM THAT OF THE PRE-CALIBRATION.
Given that the TPS reset is also carried out when
the control unit is replaced, place the control unit -
filter box bellows fixing clip at 45° upon refitting as
shown in the photograph.
INJEC - 192
SPORTCITY CUBE 250 - 300
Advertisement
Table of Contents
