Hardware Descriptions; Front Panel - Tenda O6 User Manual

Get to Know the Device

1.3 Hardware descriptions

1.3.1 Front panel

Item Port / Button
① GND
② OFF/STA/AP
③ Bridge/RST
Description
Used to protect the device from surge and lightning. To achieve that, please connect
the GND port to the grounding bar of a building with a grounding cable and the
included grounding screw.
Used to adjust operation mode of the device.

OFF: the default position. When it is on OFF position, you can change
operation mode through web UI.

STA: When it is on STA position, the device only works at station mode and you
can't change the operation mode through web UI.

AP: When it is on AP position, the device only works at AP mode and you can't
change the operation mode through web UI.
Used to bridge two devices or reset the device.

To bridge two devices:
1. Press and hold this button for 3~7 seconds on an O6 that works in AP
mode. When you release the button, LED1/LED2/LED3 starts blinking.
2. Within two minutes, press and hold this button for 3~7 seconds on
another O6 that works in Station mode. When you release the button,
LED1/LED2/LED3 starts blinking and the two devices start to bridge.
LED1/LED2/LED3 of the two devices will light off and when they light and keep
solid, it indicates that the two deivces bridge successfully.

To reset the device:
Press and hold this button for over 15 seconds to restore the device to factory
default.
- 5 -