This chapter explains how to connect the Access Point for setup,the detail
process as below:
1.
Connect your Ethernet network cable to your network router or switch
or PC. Then connect the other end of the network cable to the
TWL54A/54A+'s LAN port
2.
connect the power adapter to the AP's Power port.Then plug the power
adapter into an electrical outlet.The LEDs on the front panel will light up
as soon as the AP's powers on.
Then, the wireless adapter can associate with the AP.
Refer to the topology below:
Instruction Manual TWL54A Access Point
Chapter 2 Hardware Installation
Diagram of connection
4