Wireless; Basic - Tenda O6 User Manual

Web UI Functions
Step 3: Set up VLAN parameters of AP2.
This step is similar to that of AP1. One difference is that enter 20 in WLAN Interface field.
Step 4: Set up VLAN parameters of the switch (Here we take Tenda TEG1224T as an example.)
Switch Port
Port 1 (Connect to Gateway)
Port 3 (Connect to AP1)
Port 6 (Connect to AP2)
Step 5: Set up VLAN parameters of the gateway
The port connecting to the switch should allow VLAN 10 and VLAN 20 to get through.

4.4 Wireless

Wireless settings contain the following:

Basic: On this page, you can set up basic wireless parameters of this device, such as SSID, broadcast SSID,
encryption type, etc.

Advanced: On this page, you can set up advanced wireless parameters of this device. You can keep the default
value if you're not familiar with these parameters.

Access Control: On this page, you can set up rules to forbid or permit specified wireless clients to access this
device. The rules are based on MAC address.

4.4.1 Basic

On this page, you can set up basic wireless parameters of this device, such as SSID, broadcast SSID, encryption type,
etc.
Allowed VLAN ID
1, 10, 20
1,10
1,20
-39-
Port Type PVID
Trunk port 1
Trunk port 1
Trunk port 1