Table of Contents
Advertisement
2.1 Before Installation
To inspect the location for installing the equipment: Please decide the
quantity of the equipments to be installed, and select the location for
installing the equipment. For example, top of building, or other high
buildings. And marked each location in chart, and distribute channels
for each machine.
To configure on the device: To configure IP address, channels, and
SSID
To select location: Please install the equipment in the select location,
fix it, and connect the cable and power lines, and adjust the direction of
the antenna
To test in the location: To check if the covering rage and strength of
signal is satisfactory. You could adjust the location of the equipment
according to the test result.
2.2 Steps for Hardware Installation
Please install with references to the figure below for hardware installation:
54Mbps Wireless Long Range Wireless AP
Chapter Two Installation
3
Advertisement
Table of Contents
