Table of Contents
Advertisement
sudo /usr/local/sf/bin/configure_console.sh vga
—
To access the appliance using the physical serial port:
sudo /usr/local/sf/bin/configure_console.sh serial
—
To access the appliance using LOM via SOL:
sudo /usr/local/sf/bin/configure_console.sh sol
3.
To implement your changes, reboot the appliance by typing
The appliance reboots.
Using the Web Interface to Redirect the Console Output
Procedure
1.
Select
System > Configuration.
2.
Select
Console Configuration.
3.
Select a remote console access option:
—
Select
VGA
—
Select
Physical Serial Port
If you selected
4.
To configure LOM via SOL, enter the appropriate settings:
—
DHCP Configuration
—
IP Address
to be used for LOM. The LOM IP address must be different from the management interface IP
address of the appliance.
—
Netmask
for the appliance.
—
Default Gateway
5.
Click
Save
.
Remote console configuration for the appliance is saved. If you configured Lights-Out Management, you must
enable it for at least one user; see
Restoring a Firepower Management Center to Factory
Defaults
Cisco provides ISO images on its Support Site for restoring, or reimaging, Firepower Management Centers to their
original factory settings.
For more information, see the following sections:
Before You Begin, page 13
Understanding the Restore Process, page 13
Obtaining the Restore ISO and Update Files, page 14
Beginning the Restore Process, page 15
Using the Interactive Menu to Restore an Appliance, page 17
Next Steps, page 23
Cisco Firepower Management Center Getting Started Guide
to use the appliance's VGA port. This is the default option.
to use the appliance's serial port, or to use LOM/SOL on a Management Center.
, the LOM settings appear.
Physical Serial Port
for the appliance (
for the appliance.
Enabling LOM and LOM Users, page
Restoring a Firepower Management Center to Factory Defaults
sudo reboot
or
).
DHCP
Static
.
25.
12
Hide quick links:
Advertisement
Table of Contents
