Access Panel - HP ProOne 600 G3 Maintenance & Service Manual

Access panel

The computer has one main rear access panel that allows access to internal components. Two screws secure
the access panel.
To remove the access panel:
1. Prepare the computer for disassembly (see
2. Remove the rear port cover (see
3. Remove the stand (see
4. Pull up at the two recessed areas on at bottom of the access panel, and then lift the access panel off the
computer.
5. Lift the access panel off the computer.
To replace the access panel, reverse the removal procedures.
24 Chapter 4 Removal and Replacement Procedures
Preparing to disassemble the computer on page
Rear port cover on page
Attaching and removing a stand on page
23).
20).
19).