Attaching And Removing A Stand; Attaching And Removing An Easel Stand; Attaching An Easel Stand; Removing An Easel Stand - HP ProOne 600 G3 Maintenance & Service Manual

Attaching and removing a stand

Two stands are available for the computer:
●

Attaching and removing an easel stand

● Attaching and removing an adjustable height stand
Attaching and removing an easel stand

Attaching an easel stand

To install the stand:
1. Place the computer face down on a soft flat surface. HP recommends that you set down a blanket, towel,
or other soft cloth to protect the bezel and screen surface from scratches or other damage.
2. Engage the hooks in the top of the stand in the two large holes in the upper part of the back of the
computer (1).
3. Rotate the stand down until it clicks into place (2).

Removing an easel stand

To remove the stand:
1. Remove all removable media, such as optical discs or USB flash drives, from the computer.
2. Turn off the computer properly through the operating system, then turn off any external devices.
3. Disconnect the AC power cord from the AC outlet and disconnect any external devices.
4. Place the computer face down on a soft flat surface. HP recommends that you set down a blanket, towel,
or other soft cloth to protect the bezel and screen surface from scratches or other damage.
5. Remove the rear port cover, if it is installed. For instructions, see
6. Press the release latch under the stand (1).
20 Chapter 4 Removal and Replacement Procedures
Rear port cover on page 23.