Feet, Rear I/O Bracket, And Bottom Panel - HP ProOne 600 G3 Maintenance & Service Manual

Feet, rear I/O bracket, and bottom panel

The rear I/O bracket and bottom panel are located at bottom of the computer.
To remove the rear I/O bracket and bottom panel:
1. Prepare the computer for disassembly (see
2. Remove the rear port cover (see
3. Remove the stand (see
4. Remove the access panel (see
5. Remove the serial/PS2 board (see
6. Remove the top trim (see
7. Remove the left trim (see
8. Remove the right trim (see
9. Remove the screw that secures each foot to the computer, and then remove the feet.
NOTE:
10. Remove the two screws (1) that secure the bottom panel, and then lift it off the computer (2).
52 Chapter 4 Removal and Replacement Procedures
Rear port cover on page
Attaching and removing a stand on page
Access panel on page
Top trim on page
Left trim on page
Right trim on page
The left foot is shown in the following image.
Preparing to disassemble the computer on page
23).
24).
Serial/PS2 board on page
47).
51).
50).
20).
38).
19).