Troubleshooting - Adaptec AIC-7890 User Manual

AIC-7890 Ultra2 Wide SCSI Host Adapter User's Manual


 2    <  
To reboot the computer with the new kernel, follow these steps:
1. Follow the onscreen instructions to reboot your system,
usually by pressing Enter.
2. Check the host adapter BIOS messages to verify that
all your installed SCSI devices are listed.
If some or all of your installed SCSI devices do not
appear at this time, your SCSI cables may be loose, or
the SCSI device setup may not be complete. If so, go
back and correct any problem before proceeding.
3. Wait for UNIX to complete bootup with the new kernel.
Refer to Troubleshooting if the system crashes or if
panic (UNIX error) messages are displayed during
bootup.
The  4 7! driver for your 7800 Family host adapter
should now be ready for use.

&   + *2  $ %
This section contains useful information on using SCO UNIX
and your host adapter.

  3+  ( ) 
If you are adding an additional 7800 Family host adapter to a
system with a 7800 Family host adapter already installed, follow
the instructions in the SCO UNIX documentation for adding
devices using the + command. W hen the system asks for
the host adapter prefix, type   or   and press .
Software
75