aus Installation and connection
Connect the appliance to an
alternating current only, ranging from
220 V to 240 V and 50 Hz or 60 Hz
via a correctly installed socket with
protective earth conductor. See
rating plate for required fusing 9*.
The socket must be near the
appliance and freely accessible
If the plug is not freely accessible, an
allpole disconnector with a contact
opening of at least 3 mm must be
fitted on the installation side to
satisfy the relevant safety
The connection may be modified
by technicians only.
A power cord extension may be
purchased from customer service
Use only a residual current operated
circuit-breaker which features the
symbol ‚. Only this extension
guarantees compliance with
the currently valid regulations.
The appliance features a water
damage protection system. Please
note the system will function only
when the power supply
the sequence of worksteps here.
Disconnect the appliance from the
Turn off the tap.
Undo the waste water and drinking
Loosen fastening screws for the
If fitted, remove the base panel.
Pull out the appliance, carefully
pulling the hose behind.