Bosch SM series Instruction Manual page 33

Fault
Fault code ":ƒˆ is lit.
A different fault code is
indicated on the digital
display.
(":‹‚ to ":„‹)
p or • appears on the
digital display h. *
Refill indicator for rinse aid
` is lit.
Refill indicator for rinse aid
` is not lit.
Water is left in the
appliance at the end of the
programme.
Reason
Mains voltage too low.
A technical fault has probably
occurred.
Not a fault!
No rinse aid.
Refill indicator switched off.
There is still enough special rinse
aid available.
Filter system or area under the
filters 1J is blocked.
Programme not finished yet
Fault, what to do? aus
Solution
No appliance fault, have the mains voltage
and electrical installation checked.
Switch off the appliance with the ON/OFF
switch (.After a short time, restart the
appliance.
If the problem recurs, turn off the tap and
pull out the mains plug.
Call customer service and mention the
fault code.
See TurboSpeed 20 min. in the chapter
"Overview of programmes". *
Refill rinse aid.
Activation/Deactivation. ~ Page 13
Check the filling level, refill indicator.
Clean filters and area underneath (see
"Waste water pump").
Wait until programme ends or reset (see
"Terminating the programme").
33