Auto Power Off; Switching Off The Appliance; Interrupting The Programme; Terminating The Programme - Bosch SM series Instruction Manual

Auto Power Off (Automatic
switch off after end of
programme)
To save power you can set the
A u t o P o w e r O f f
dishwasher to switch off automatically
from 1 minute to 120 minutes after the
end of its programme. You can choose
a setting from ˜:‹‹ to ˜:‹ƒ.
˜:‹‹ Appliance does not switch off
automatically.
˜:‹‚ Appliance switches off after 1
minute.
˜:‹ƒ The appliance switches off after
120 minutes.
Here's how to change the setting:
Switch on ON/OFF switch (.
1.
Hold down the programme button
2.
# and then repeatedly press the
START button P until š:‹...
appears in the display window.
Release both buttons.
3.
The LED of the # button flashes
and the digital display h lights up
to show the value š:‹....
Press the programme button #
4.
repeatedly until the value ˜:‹...
appears in the display window h.
Press the programme button 3.
5.
Each time the button is pressed, the
set value increases by one level;
when it reaches the value ˜:‹ƒ the
display jumps back to ˜:‹‹.
Press START button P.
6.
The set value is saved.
Operating the appliance aus

Switching off the appliance

Shortly after the end of the
programme:
Switch off ON/OFF switch (.
1.
Turn off water supply (does not
2.
apply to appliances with Aqua-Stop).
Remove the utensils when they have
3.
cooled down.
When the programme ends,
Note:
leave the appliance to cool down a
while before opening it. This will prevent
steam from escaping and causing
long-term damage to your built-in
furniture.

Interrupting the programme

Caution!
Expansion (overpressure) may cause
the appliance door to jump open and/or
water to escape! If the door was opened
on an appliance which has a hot water
connection or is heated, always leave
the door ajar for several minutes and
then close it.
Switch off ON/OFF switch (.
1.
The LEDs go out. The programme is
saved.
Switch on the ON/OFF switch (
2.
again to continue the programme.

Terminating the programme

(Reset)
Press the START button P and
1.
p r o g r a m m e T e r m i n a t i n g t h e
hold it down for about 3 seconds.
The value ‹:‹‚ appears in the
display window h. The
programme sequence lasts about
1 minute. The value ‹:‹‹ appears in
the display window h.
Switch off ON/OFF switch (.
2.
27