For The Installer; General Information For The Installer Transport And Storage; Supplied Components; Assembly - Nibe SPLIT ACVM 27 Installation And Maintenance Instructions Manual

For the Installer

General information for the installer
General information for the installer
Transport and storage
Outdoor module AMS 10
AMS 10 should be transported and stored vertically.
If the heat pump is to be lifted using lifting straps without
packaging, protect as illustrated.
The right-hand side of the heat pump (seen from the front)
is heavier.
Indoor module ACVM 270
ACVM 270 can be transported horizontally or vertically and
must be stored vertically and in dry conditions.

Supplied components

Outside sensor
Current sensor, 3 phase
The enclosed kit is located behind the front service cover in
ACVM 270.
16
Straps for 1 phase connection
Safety valve with manometer

Assembly

Outdoor module AMS 10
Position AMS 10 outdoors secured to a firm surface, prefer-
ably concrete foundation near walls with ground stand or
wall mounting. The distance between the ground and AMS
10 must be at least 200 mm. AMS 10 should not be posi-
tioned next to noise sensitive walls, for example, next to a
bedroom. Also ensure that the placement does not inconveni-
ence the neighbours. Care must be exercised so that the
heat pump is not scratched during installation.
Large amounts of condensation water as well as melt
water from defrosting can be produced. Provide good
drainage at the installation area and make sure water cannot
run out onto paths or the like during periods that ice can
form.
The distance between AMS 10 and the house wall must be
at least 150 mm. Ensure that there is at least one metre free
space above AMS 10. AMS 10 must not be placed so that
recirculation of outdoor air can occur. AMS 10 must not
be placed in a windy location where it is exposed to
direct strong winds. This causes lower output and im-
paired efficiency.
For wall installation, ensure that vibrations do not affect the
inside of the house. Also ensure that the wall and mounting
can take the weight of the heat pump.
Indirect offshore wind
Weak wind: > 0.5 km
Strong wind: > 3 km
NIBE™ SPLIT
Direct offshore wind
Weak wind: > 1 km
Strong wind: > 10 km