Installing The Bezel - Fortinet FortiAnalyzer-2000B Rack And Hardware Install Manual

Installing the Bezel

Installing the Bezel
18
Figure 12: Cabling the system using the CMA
12
13
• With the CMA in the service position, route the cable bundle through the inner and
outer baskets (12).
• Use the preinstalled Velcro straps on either end of the baskets to secure the cables
(13).
• Adjust the cable slack as needed at the hinge position (14).
• Swing the CMA back into place on the tray (15).
• Install the status indicator cable at the back of the system and secure the cable by
routing it through the CMA. Attach the other end of this cable to the corner of the
outer CMA basket. (16).
A lock on the bezel restricts access to the power button, optical drive, and hard drive(s).
The LCD panel and navigation buttons are accessible through the front bezel.
To remove the Front Bezel
1 Using the system key, unlock the bezel.
2 Pull up on the release latch next to the key lock.
3 Rotate the left end of the bezel away from the system to release the right end of the
bezel.
4 Pull the bezel away from the system. See Figure 13.
11
14
FortiAnalyzer-2000B Version 4.0 MR1 Rack and Hardware Install Guide
Rack Installation Instructions
16
15
Revision 1
http://docs.fortinet.com/ • Feedback