Fortinet FortiAnalyzer-100A/100B Quick Start Manual

FortiAnalyzer Unit LED Indicators
LED State
Green
Power
Off
Status On
On
10/100
Off
Flashing
Link Act
On

Checking the Package Contents

Connector
Ports 1, 2, 3, 4
CONSOLE
Connecting
Connect the FortiAnalyzer unit to a power outlet and to the network hub or switch.
• Place the FortiAnalyzer unit on a stable surface. It requires 1.5 inches (3.75 cm) clearance
on each side to allow for cooling.
• Make sure the power is not plugged into the wall before connecting the power cable.
• The Status light flashes while the unit is starting up and remains lit when the system is up
and running.

Planning the Configuration

You can add the FortiAnalyzer unit to your local FortiGate network to receive log messages
from your local FortiGate units, or connect the FortiAnalyzer unit to the FortiGate units re-
motely using FortiManager. To connect the FortiAnalyzer unit to the FortiGate units remotely,
you must configure the DNS server and the default gateway.
To manage the FortiAnalyzer unit, you can use a computer within the local network or over
the Internet.

Factory Defaults

User name:
Administrator Account
Password:
IP:
Port 1 Netmask:
Management Access:
IP:
Port 2 Netmask:
Management Access:
IP:
Port 3 Netmask:
Management Access:
IP:
Port 4 Netmask:
Management Access:
Description
The FortiAnalyzer unit is on.
The FortiAnalyzer unit is off.
FortiAnalyzer unit is running normally.
The interface is connected at 100 Mbps.
The interface is connected at 10 Mbps.
Network activities on the FortiAnalyzer unit
Interface connected
1 2 3 4
10/100
POWER
STATUS LINK / ACT
Power LED
Interface
Status LED
status LEDs
Type Speed Protocol
RJ-45 10/100Base-T Ethernet
DB-9 9600 bps RS-232
admin
(none)
192.168.1.99
255.255.255.0
ping, https, http, ssh
192.168.2.99
255.255.255.0
ping, https, http, ssh
192.168.3.99
255.255.255.0
ping, https, http, ssh
192.168.4.99
255.255.255.0
ping, https, http, ssh
© Copyright 2006 Fortinet Incorporated. All rights reserved.
Products mentioned in this document are trademarks or registered trade-
marks of their respective holders.
Regulatory Compliance
FCC Class A Part 15 CSA/CUS
18 September 2006
4 3 2 1
DC+12V
Power (future)
Connection
Internal Interface,
switch connectors
1,2,3,4
RS232 Serial
Connection
Description
Connection to the network
Connection to the management computer. Provides
access to the command line interface (CLI).
Power cable connects
to power supply.
Optional null modem cable connects to
serial port on management computer.
POWER
STATUS
FortiAnalyzer-100A/100B
USB
Grey - Straight-through
USB
Power Cable Power Supply
4 3 2
DC+12V
Straight-through Ethernet cable connects
to hub or switch on the network.
1 2 3 4
10/100
LINK / ACT
05-30003-0223-20060918
Ethernet Cables:
Orange - Crossover
Null-Modem Cable
(RS-232)
Q u i c k S t a r t G u i d e
1 2 3 10/100 4
STATUS POWER LINK / ACT
FortiAnalyzer-100A/100B
Copyright 2006 Fortinet Incorporated. All rights reserved.
Trademarks
Products mentioned in this document are trademarks.
Documentation
USB
1