Liko Likorall 200 Assembly Instruction Manual page 12

9 End stop
• Inspect that safetythrough bolts with locking nuts are
9 End stop
mounted.
• Inspect that safetythrough bolts with locking nuts are
• Inspect that the end stop is correctly mounted.
mounted.
• Inspect that the end stop is correctly mounted.
10 Rail Joint (in rail, pendant and ceiling bracket)
• Inspect the Rail Joint to make sure that bolts and nuts
10 Rail Joint (in rail, pendant and ceiling bracket)
are tightened and there is no play between the parts.
• Inspect the Rail Joint to make sure that bolts and nuts
• Make sure the Rail Joint is assembled with the joints in
are tightened and there is no play between the parts.
the middle.
• Make sure the Rail Joint is assembled with the joints in
the middle.
11 Lift motor
• See Periodic inspection for the particular lift /product in the rail system.
11 Lift motor
(Available at www.partner.liko.net)
• See Periodic inspection for the particular lift /product in the rail system.
(Available at www.partner.liko.net)
12 Maximum load rail system
• Carry out load test with lift motor carriages and rail
12 Maximum load rail system
system, using maximum load for the rail system, across
• Carry out load test with lift motor carriages and rail
the whole lifting area, by manoeuvre the load along
system, using maximum load for the rail system, across
each primary rail, and then in a Z pattern.
the whole lifting area, by manoeuvre the load along
• Listen for unusual noises and vibrations. Check for any
each primary rail, and then in a Z pattern.
abnormalities such as deflection, abnormal movement
• Listen for unusual noises and vibrations. Check for any
or resistance.
abnormalities such as deflection, abnormal movement
or resistance.
ServiceManual Likorall™ overhead lift (3EN200405 Rev 10)
Periodic Inspection Rail System, 3EN111001 Rev. 10
Likorall™
Instructions for inspection points
Instructions for inspection points
117
6.2
www.liko.com
www.liko.com