Liko Likorall 200 Assembly Instruction Manual
  1. Manuals
  2. Brands
  3. Liko Manuals
  4. Lifting Systems
  5. Likorall 200
  6. Assembly instruction manual

Liko Likorall 200 Assembly Instruction Manual

Overhead lift motors
Hide thumbs Also See for Likorall 200:

Advertisement

Table of Contents

See also: Service Manual , Instruction Manual
Contains:
Emergency guard strap, long
Fits:
Likorall (with emergency guard)
1. Thread the emergency guard strap through the intended holes.
2. Cut the emergency guard strap to a reachable length. (approx. 1,8 meter / 70 inch from the floor).
Seal the end of the emergency guard strap (e.g. by heating it or with textile adhesive)
NOTE
- Make sure the spare part is mounted according to the assembly instruction.
- Check all functions related to the changed spare part.
- Repairs and maintenance may only be performed by personnel authorized by Hill-Rom/Liko and using original Liko spare parts.
ServiceManual Likorall™ overhead lift (3EN200405 Rev 10)
© Copyright Liko AB
Likorall™
Qty:
1
106
Emergency Guard Strap
Nödstoppsband
Assembly Instruction
Monteringsanvisning
Prod. No. 31290123
3SE690238 Rev. 1
2013-12-05
Tools required:
www.liko.com
www.liko.com
5.537

Advertisement

Table of Contents
loading

Related Manuals for Liko Likorall 200

Summary of Contents for Liko Likorall 200

  • Page 1 - Make sure the spare part is mounted according to the assembly instruction. - Check all functions related to the changed spare part. - Repairs and maintenance may only be performed by personnel authorized by Hill-Rom/Liko and using original Liko spare parts. www.liko.com www.liko.com...

  • Page 2: Periodic Inspection

    “To be actioned” these actions should be performed immediatley. After performed actions sign below. If anything is unclear or if you have questions, please contact Hill-Rom/Liko or your local Hill-Rom/Liko representative. Contact information is to be found at www.liko.com.
  • Page 3 Likorall™ Instructions for the inspection points Inspection points Likorall 200 Likorall 242 Likorall 243 & 250 www.liko.com www.liko.com Periodic Inspection Likorall Periodic Inspection Likorall www.liko.com ServiceManual Likorall™ overhead lift (3EN200405 Rev 10)

  • Page 4: Emergency Lowering

    With the emergency-stop out, press each button and check for corresponding lift operation. 5 Electrical emergency lowering device Test the electrical emergency lowering device by pulling down the handle (Likorall 200) or pressing the up and down arrows on the electronic card cover. Check for corresponding lift operation.
  • Page 5 Likorall™ Instructions for the inspection points 9 TDM & R2R Hook (Likorall 242 R2R and Likorall 200) Manually press and lower the plastic covers and spring assembly away from the aluminium hook. Release the spring assembly and verify that the spring snaps back against the hook, providing a secure snap-fit lock. Verify that the screw joints are tight.
  • Page 6 3. Cracks in the paint and red corrosion under the paint is a sign of corroding steel. Corroding steel will result in material loss and should therefore be replaced. 4. A component with peeling coating, bubbles in the paint and red corrosion under the paint is unfit to use. www.liko.com ServiceManual Likorall™ overhead lift (3EN200405 Rev 10) www.liko.com Periodic Inspection Likorall...
  • Page 7 Likorall™ Instructions for the inspection points Safety critical fixing points: Example of load bearing parts: • Carrier bolts and pins • Load bearing components below lift motor. www.liko.com ServiceManual Likorall™ overhead lift (3EN200405 Rev 10)

  • Page 8: Installation

    To be actioned: Actions according to the “Instructions for the inspection points” should be performed immediatley. After performed actions sign below. If anything is unclear or if you have questions, please contact Hill-Rom/Liko or your local Hill-Rom/Liko representative. Contact information is to be found at www.liko.com.
  • Page 9 Perform corrosion e.g. indoor pool section 15. section 15. inspection according to section 15. NOTE! NOTE! Make inspection with Make inspection with inspection hatches or inspection hatches similar. or similar. www.liko.com Periodic Inspection Rail System, 3EN111001 Rev. 10 www.liko.com ServiceManual Likorall™ overhead lift (3EN200405 Rev 10)
  • Page 10 Märklast / Max load installed in the system. TESTED www.liko.com 3 Ceiling / Pendant / Ceiling Fixture • Inspect a minimum of 20% (at least two) of the fixing points to make sure that bolts and nuts are not loose, or see “Installation condition checklist”...
  • Page 11 The secondary rail (B) should then run freely. 8 Traverse Carriage • Inspect that the carriers are functioning correctly with- out exercise. Listen for abnormal sounds from movable parts. www.liko.com www.liko.com ServiceManual Likorall™ overhead lift (3EN200405 Rev 10) Periodic Inspection Rail System, 3EN111001 Rev. 10...
  • Page 12 11 Lift motor • See Periodic inspection for the particular lift /product in the rail system. 11 Lift motor (Available at www.partner.liko.net) • See Periodic inspection for the particular lift /product in the rail system. (Available at www.partner.liko.net) 12 Maximum load rail system •...
  • Page 13 • Listen for unusual noises and vibrations. Check for any abnormalities such as deflection, movement or resistance. Pendant Pendant End Stop Carriage Primary rail Max.load Max.load Pause Attachment 1 etc. End stop End stop Carriage Rail Max.load www.liko.com ServiceManual Likorall™ overhead lift (3EN200405 Rev 10) www.liko.com Periodic Inspection Rail System, 3EN111001 Rev. 10...

  • Page 14: Traverse System

    Secondary rail Max.load Max.load Secondary rail Max.load Max.load Pause Attachment 1 etc. End stop End stop Secondary rail End stop End stop Max.load Max.load www.liko.com ServiceManual Likorall™ overhead lift (3EN200405 Rev 10) www.liko.com Periodic Inspection Rail System, 3EN111001 Rev. 10...
  • Page 15 3. Cracks in the paint and red corrosion under the paint is a sign of corroding steel. Corroding steel will result in material loss and should therefore be replaced. 4. A component with peeling coating, bubbles in the paint and red corrosion under the paint is unfit to use. www.liko.com ServiceManual Likorall™ overhead lift (3EN200405 Rev 10) www.liko.com Periodic Inspection Rail System, 3EN111001 Rev. 10...
  • Page 16 Example of load bearing bolts and nuts: - Pendants - Ceiling and wall brackets - Traverse carriers - Switches and turntables • End stop www.liko.com ServiceManual Likorall™ overhead lift (3EN200405 Rev 10) www.liko.com Periodic Inspection Rail System, 3EN111001 Rev. 10...
  • Page 17 Likorall™ www.liko.com ServiceManual Likorall™ overhead lift (3EN200405 Rev 10)

  • Page 18: Preventative Maintenance

    Prod. Year: (Zip Code) To ensure maximum life cycle should Preventative Maintenance be carried out according to the table below. Inspection and service must be carried by HillRom/Liko authorized personnel. Instructions for the check points, from the next page. Check points:...

  • Page 19: Check Points

    Likorall™ Check points 4A&B Instructions regarding the check points for Likorall 200/240/242/243/250 1. Carriage cleaning Tools required 13 mm Adjustable A. Remove the carriage from the rail and brake clean the wheels and the inside surface of rails with a moist cloth.
  • Page 20 Likorall™ Likorall 200/240/242/243/250 2. Bearing inspection and replacement Tools required Spare part No: 31290060 Plastic wheel with bearing. Not for IRC-carriage 3126114 and IRC Traverse Adapter 3102540 Bearing replacement recommended every 5th year 3. Lift strap replacement Spare part No. according to spare part list.
  • Page 21 Likorall™ Likorall 200/240/242/243/250 5. Sling bar cleaning Tools required Only on SlingBar Standard: 17 mm 6 mm A. Unfasten sling bar from Likorall. B. Clean sling bar and center bolt on old type of slingbar. Cleaning of sling bar and center bolt recommended every year www.liko.com...

  • Page 22: Product Changes

    Likorall™ Likorall 200 / 240 / 242 / 243 / 250 Product changes Likorall 200 Prod. No. 3121001 Likorall 242 ES Prod. No. 3122005-3122006 / NA Likorall 242 ES R2R Prod. No. 3122007-3122008 / NA Likorall 243 ES, NA Likorall 242 S Prod.
  • Page 23 Product changes 2012 Changes Type Prod. No. Rev. From S/N: Proj. - New longer and grey lift straps. Likorall 200 3121001 8 406 676 1748 - The motor has been modified. 1817 - New version of PCBA Likorall 242 S...
  • Page 24 Likorall™ 200 / 240 / 242 / 243 / 250 Product changes 2011 Changes Type From S/N Project New layout on decal and product labels. Likorall 200 1690/1694 New layout on decal and product labels. Likorall 242 S 1690/1694 Likorall 242 ES Likorall 243 ES Likorall 250 ES...
  • Page 25 Likorall™ 200 / 240 / 242 / 243 / 250 Product changes 2009 Changes Type From S/N Project New version of electronic card; version F Likorall 200 8 401 051 1030 2007 Changes Type From S/N Project New version of Electronic card.
  • Page 27 . l i k o . com Manufacturer: Liko AB SE-975 92 Luleå Sweden...

This manual is also suitable for:

Likorall 240Likorall 242Likorall 243Likorall 250

Table of Contents