Steering Exp "Stexp - RadioLink RC3S Instruction Manual

button to select the desired setting item , press "Enter" key the initial value of your
selected setting item will blink, then you can press "Dec(-)" or "Inc(+)" button to
adjust the value of your selected setting item.
(Note: In the interface of adjusting the value, return to the initial value "120" by
pressing "Dec(-)" and "Inc(+)" buttons simultaneously for about 1 second.)
3. Press "Enter" button, the adjusted value of your selected setting item stops blinking,
now the value of your selected setting item has been set.
4. Return to the initial screen by pressing "Exit" button twice.

Steering EXP "STEXP"

This function is used to change the sensitivity of the steering servo around the neutral
position. It has no effect on the maximum servo travel.
and both ends
Adjust the sensitivity 0f direction wheel both in neutral position and ends
Setup item
RATE: Steering EXP rate
Adjustment range
-100~0~+100
Initial value :0
0~-100 Sensitivity around neutral position is low,getting higher when approaching ends.
0 Sensitivity around the neutral and ends position is equal
0~+100 Sensitivity around neutral position is high,getting lower when approaching ends
Steering operation curve adjustment
1.Access the function menu (By pressing "Exit" and "Enter "buttons simultaneously
and holding them down for one second ), press "Inc(+) " button three times to chose
EAP function.
2.Press "Enter" button to get into STEXP function interface, press "Enter "key and
the initial value of the rate will blink, then you can press "Dec(-) " or "Inc(+) "button
to adjust the value and the curve of the rate shown in the figure will change
correspondingly.
(Note: In the interface of adjusting the value, return to the initial value "0"by pressing
"Dec(-)" and "Inc(+)" buttons simultaneously for about 1 second. )
11