Power On Level Setup; Volume Limit Setup - Pioneer VSX-919AH-S Operating Instructions Manual

The system and the other setup
• Fixed – Use this setting if you've connected
a fully integrated amplifier (such as
another Pioneer VSX receiver) in the sub
room and want to use that receiver's
volume controls.
With the Fixed setting, the source is sent from
this receiver at maximum volume, so make
sure the volume is quite low in the sub zone at
first, and then experiment to find the correct
level.
3 When you're finished, press RETURN.
You will return to the Other Setup menu.

Power ON Level Setup

The volume can be set so that it is always set to
the same level when the receiver's power is
turned on.
1 Select 'Power ON Level Setup' from the
Other Setup menu.
4d.Other Setup
A/V RECEIVER
1. KURO LINK Setup
2. Multi Ch In Setup
3. ZONE Audio Setup
4. Power ON Level Setup

5. Volume Limit Setup

6. Remote Control Mode Setup
7. Flicker Reduction Setup
4d4.Power ON Level Setup
Power ON Level
Exit
Exit
2 Select the Power ON Level setting you
want.
• LAST – When the power is turned on, the
volume is set to the same level as when the
power was last turned off.
• "---" – When the power is turned on, the
volume is set to minimum level.
• -80.0dB to +12.0dB – Specify the volume to
be set when the power is turned, in steps of
0.5 dB.
It is not possible to set a volume level greater
than the value specified at Volume Limit Setup.
A/V RECEIVER
: LAST
Return
Finish
3 When you're finished, press RETURN.
You will return to the Other Setup menu.
Volume Limit Setup
Use this function to limit the maximum
volume. The volume cannot be increased
above the level set here, even by operating
MASTER VOLUME button (or the dial on the
front panel).
1 Select 'Volume Limit Setup' from the
Other Setup menu.
4d.Other Setup
A/V RECEIVER
1. KURO LINK Setup
2. Multi Ch In Setup
3. ZONE Audio Setup
4. Power ON Level Setup
5. Volume Limit Setup
6. Remote Control Mode Setup
7. Flicker Reduction Setup
4d5.Volume Limit Setup
Volume Limit
Exit
Exit
2 Select the Volume Limit setting you want.
• OFF – The maximum volume is not limited.
• -20.0dB/-10.0dB/0.0dB – The maximum
volume is limited to the value set here.
3 When you're finished, press RETURN.
You will return to the Other Setup menu.
A/V RECEIVER
: OFF
Return
Finish
11
99
En