Better Sound Using Phase Control - Pioneer VSX-919AH-S Operating Instructions Manual

06 Listening to your system
– WMA9 Pro lights to indicate that a WMA9
Pro signal is being decoded.
• HDMI is not assigned by default. To select
an HDMI signal, conduct the input setup
procedure (see The Input Setup menu on
page 40).
Better sound using Phase
Control
This receiver's Phase Control feature uses
phase correction measures to make sure your
sound source arrives at the listening position
in phase, preventing unwanted distortion and/
or coloring of the sound.
Phase Control technology provides coherent
sound reproduction through the use of phase
1
matching
for an optimal sound image. The
default setting is on and we recommend
leaving Phase Control switched on for all
sound sources.
• Press RECEIVER
(PHASE CONTROL) to switch on phase
correction.
The PHASE CONTROL indicator on the front
panel lights.
Note
1 • Phase matching is a very important factor in achieving proper sound reproduction. If two waveforms are 'in phase',
they crest and trough together, resulting in increased amplitude, clarity and presence of the sound signal. If a crest
of a wave meets a trough, then the sound will be 'out of phase' and an unreliable sound image will be produced.
• The PHASE CONTROL feature is available even when the headphones are plugged in.
• If your subwoofer has a phase control switch, set it to the plus (+) sign (or 0°). However, the effect you can actually
feel when PHASE CONTROL is set to ON on this receiver depends on the type of your subwoofer. Set your subwoofer
to maximize the effect. It is also recommended you try changing the orientation or the place of your subwoofer.
• Set the built-in lowpass filter switch of your subwoofer to off. If this cannot be done on your subwoofer, set the cutoff
frequency to a higher value.
• If the speaker distance is not properly set, you may not have a maximized PHASE CONTROL effect.
• The PHASE CONTROL mode cannot be set to ON in the following cases:
– When the PURE DIRECT mode is switched on.
– When the MULTI CH IN input is selected.
– When the HDMI audio output parameter is set to THROUGH in Setting the Audio options on page 63.
58
En
, then press PHASE CTRL