Pioneer VSX-919AH-S Operating Instructions Manual page 79

The Advanced MCACC menu
4 When you're finished setting the options,
select START then press ENTER.
5 Follow the instructions on-screen.
• Make sure the microphone is connected.
• If you're using a subwoofer, it is
automatically detected every time you
switch on the system. Make sure it is on
and the volume is turned up.
• See Problems when using the Auto MCACC
Setup on page 40 for notes regarding high
background noise levels and other possible
interference.
6 Wait for the Auto MCACC Setup to finish
outputting test tones.
A progress report is displayed on-screen while
the receiver outputs test tones to determine the
speakers present in your setup. Try to be as
quiet as possible while it's doing this.
• Do not adjust the volume during the test
tones. This may result in incorrect speaker
settings.
• With error messages (such as Too much
ambient noise! or Check microphone)
select RETRY after checking for ambient
noise (see Problems when using the Auto
MCACC Setup on page 40) and verifying the
mic connection. If there doesn't seem to be
a problem, you can simply select GO NEXT
and continue.
Note
1 This screen is only shown if you selected ALL or Speaker Setting from the Auto MCACC menu.
2 If the speaker is not pointed to the microphone (listening position) or when using speakers that affect the phase
(dipole speakers, reflective speakers, etc.), Reverse Phase may be displayed even if the speakers are properly
connected.
7 If necessary, confirm the speaker
configuration in the GUI screen.
The configuration shown on-screen should
reflect the actual speakers you have.
If no operations are performed for 10 seconds
while the speaker configuration check screen
is being displayed, the Auto MCACC Setup will
resume automatically. In this case, you don't
need to select 'OK' and press ENTER in step 8.
1b.Auto MCACC
A/V RECEIVER
Now Analyzing... 2/9
Environment Check
Ambient Noise : OK
Microphone :
Speaker YES/NO :
L :
Exit
C :
R :
SR :
SBR :
SBL :
SL :
SW :
10
OK RETRY
Exit
• If you see an ERR message (or the speaker
configuration displayed isn't correct), there
may be a problem with the speaker
connection.
If selecting RETRY doesn't work, turn off
the power and check the speaker
connections. If there doesn't seem to be a
problem, you can simply use / to select
the speaker and / to change the
setting and continue.
• If Reverse Phase is displayed, the
speaker's wiring (+ and –) may be inverted.
Check the speaker connections.
–
If the connections were wrong, turn off
the power, disconnect the power cord, then
reconnect properly. After this, perform the
Full Auto MCACC procedure again.
– If the connections were right, select GO
NEXT and continue.
1
1b.Auto MCACC
A/V RECEIVER
YES
Cancel
YES
YES
YES
YES
YES
YES
YES
Cancel
2
10
79
En