HPE 3100 Configuration Manual page 216

[SwitchB-Vlan-interface100] ipv6 address 2002:3::1 64
[SwitchB-Vlan-interface100] quit
# Specify an IPv6 address for VLAN-interface 101, the physical interface of the tunnel.
[SwitchB] interface vlan-interface 101
[SwitchB-Vlan-interface101] ipv6 address 2002::22:1 64
[SwitchB-Vlan-interface101] quit
# Create service loopback group 1 to support the tunnel service.
[SwitchB] service-loopback group 1 type tunnel
# Assign Ethernet 1/0/3 to service loopback group 1, and disable STP, NDP, and LLDP on the
interface.
[SwitchB] interface Ethernet 1/0/3
[SwitchB-Ethernet1/0/3] undo stp enable
[SwitchB-Ethernet1/0/3] undo ndp enable
[SwitchB-Ethernet1/0/3] undo lldp enable
[SwitchB-Ethernet1/0/3] port service-loopback group 1
[SwitchB-Ethernet1/0/3] quit
# Create interface Tunnel 2.
[SwitchB] interface tunnel 2
# Specify an IPv6 address for interface Tunnel 2.
[SwitchB-Tunnel2] ipv6 address 3001::1:2 64
# Configure the tunnel encapsulation mode.
[SwitchB-Tunnel2] tunnel-protocol ipv6-ipv6
# Specify the IP address of VLAN-interface 101 as the source address for interface Tunnel 2.
[SwitchB-Tunnel2] source 2002::22:1
# Specify the IP address of VLAN-interface 101 on Switch A as the destination address for
interface Tunnel 2.
[SwitchB-Tunnel2] destination 2001::11:1
# Reference service loopback group 1 on the tunnel.
[SwitchB-Tunnel2] service-loopback-group 1
[SwitchB-Tunnel2] quit
# Configure a static route from Switch B through interface Tunnel 2 to Group 1.
[SwitchB] ipv6 route-static 2002:1:: 64 tunnel 2
Verifying the configuration
Display the status of the tunnel interfaces on Switch A and Switch B.
[SwitchA] display ipv6 interface tunnel 1
Tunnel1 current state :UP
Line protocol current state :UP
IPv6 is enabled, link-local address is FE80::2013:1
Global unicast address(es):
3001::1:1, subnet is 3001::/64
Joined group address(es):
FF02::1:FF13:1
FF02::1:FF01:1
FF02::1:FF00:0
FF02::2
FF02::1
MTU is 1460 bytes
206