HPE 3100 Configuration Manual page 212

Last 300 seconds input:
Last 300 seconds output:
152 packets input,
0 input error
168 packets output,
0 output error
[SwitchB] display interface tunnel 2
Tunnel2 current state: UP
Line protocol current state: UP
Description: Tunnel2 Interface
The Maximum Transmit Unit is 1460
Internet Address is 30.1.2.2/24 Primary
Encapsulation is TUNNEL, service-loopback-group ID is 1.
Tunnel source 2002::0002:0001, destination 2001::0001:0001
Tunnel bandwidth 64 (kbps)
Tunnel protocol/transport IP/IPv6
Output queue : (Urgent queuing : Size/Length/Discards)
Output queue : (Protocol queuing : Size/Length/Discards)
Output queue : (FIFO queuing : Size/Length/Discards)
Last clearing of counters:
Last 300 seconds input:
Last 300 seconds output:
167 packets input,
0 input error
170 packets output,
0 output error
# Ping the IPv4 address of the peer interface VLAN-interface 100 from Switch A.
[RouterA] ping 30.1.3.1
PING 30.1.3.1: 56
Reply from 30.1.3.1: bytes=56 Sequence=1 ttl=255 time=46 ms
Reply from 30.1.3.1: bytes=56 Sequence=2 ttl=255 time=15 ms
Reply from 30.1.3.1: bytes=56 Sequence=3 ttl=255 time=16 ms
Reply from 30.1.3.1: bytes=56 Sequence=4 ttl=255 time=15 ms
Reply from 30.1.3.1: bytes=56 Sequence=5 ttl=255 time=16 ms
--- 30.1.3.1 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 15/21/46 ms
0 bytes/sec, 0 packets/sec
0 bytes/sec, 0 packets/sec
9728 bytes
10752 bytes
Never
1 bytes/sec, 0 packets/sec
1 bytes/sec, 0 packets/sec
10688 bytes
10880 bytes
data bytes, press CTRL_C to break
202
0/100/0
0/500/0
0/75/0