Bridge Mode; Wiring Diagram; Basic Configuration Steps - HDL -MCIP-RF.10 User Manual

5- All devices exit the wireless setup mode
You are able to search and configure these wireless devices normally via the gateway
now.
5.2

Bridge Mode

5.2.1

Wiring Diagram

In bridge mode, RS485 and Ethernet data in multiple gateways can be transmitted via RF,
which effectively extends the communication distance. In the inconvenient of layout
application environment, different subnets can be interconnected.
5.2.2

Basic Configuration Steps

Basic steps to build up the bridge mode system:
1- All gateways use different Subnet ID
2- All gateways use same frequency
3- All gateways use same PSK PWD
Important Note: RF reliable transmission distance is 50m, obstacles will reduce the
transmission distance, the distance decreases 20m if through a wall, so it is better to
install mesh wireless devices in empty place and forbid to install near to the metal objects,
in order to get a good communication quality, this device is not recommended to install in
electric box, if have to, then please add an antenna outside.
Mesh Gateway – User Manual
User Manual
HDL-MCIP-RF.10
7