Basic Configuration Steps - HDL -MCIP-RF.10 User Manual

User Manual
HDL-MCIP-RF.10
5.1.2

Basic Configuration Steps

Basic steps to build up the mesh mode system:
1- Select the free frequency for the gateway, HDL-MCIP-RF.10
For China, select WPAN band, and the range of frequency is 780MHz -786MHz;
For Europe, select SRD band, and the range of frequency is 864MHz – 870MHz;
For North America, select ISM band, and the range of frequency is 904MHz – 928MHz .
2- Set the unique PSK PWD for the gateway
Must set the unique password for your gateway, then even other RF systems use same
frequency as yours, but cannot control your system devices because of different PSK
PWD.
3- All wireless devices enter the wireless setup mode
The way to enter the wireless setup mode:
Gateway:
Press the 'PROG' button 3 times continuously or enter from HDL BUS software directly, its
LED will flash quickly
Curtain:
Press the 'PROG' button 3 times continuously, its LED will flash quickly.
DLP Panel:
Long press the first and eighth buttons at the same time to enter the setting page, select
'WIRELESS', the seventh and eighth buttons' LED will be on.
Normal Panel:
Long press any button of it about 25s (at the 15s, the LED will flash quickly that means it
enters the address modify mode), the LED will flash slowly.
4- Set the wireless parameters for normal wireless devices
In the HDL BUS software, set the ID, frequency and PSK PWD for the normal wireless
devices (panel, relay, etc) via the mesh gateway. Their Subnet ID, frequency and PSK
PWD must be same as the gateway's, otherwise the gateway cannot manage them.
6
Mesh Gateway – User Manual