HDL -MCIP-RF.10 User Manual page 22

select 'WIRELESS', then it will enter the wireless setup mode
5- Click the 'Search' button again, this panel will be found in the 'Node' list.
 RSSI: normal range is 0-90, the smaller the better. If it's larger than 90, that means
the signal is too weak so need to change its installation place, near to other wireless
devices.
6- Select the node, change its ID and remark it, click Save. (the Subnet ID must be same
as the gateway's)
7- Click 'Modify Settings of Selection', and it will show 'configure successfully ', then all its
wireless parameters will follow the gateway's (Band, Frequency and PSK).
8- Click 'all Node Exit Setup', then the gateway and the panel will exit the wireless setup
mode.
Mesh Gateway – User Manual
User Manual
HDL-MCIP-RF.10
20