HIOS BLT-AY-61 Operation Manual page 23

Timing Chart 02
Start Type
Pulse start
Use "Pulse input" for the FOR in-
put to rotate the driver
FOR input
*Use "Pulse input" of 100 mS or more
RESET input
FOR
Bit rotation
REV
Screw condition
Torque up
FINISH output
2WS input Impact starts when the
screw has been seated
REV input
Impact setting value
FOR/ FOR/ REV/
HIGH LOW HIGH
U3 ー ー
Pulse is input for the FOR input and
the driver is rotated freely (if used for
meshing the screw)
On the 3rd impact when
FINISH output is ON
- 23 -
2WS setting Bit rotation
REV/
LOW
ー HIGH only FOR only
Rotate stops with
RESET