How To Switch Between Reading Start/Pulse Start - HIOS BLT-AY-61 Operation Manual

■ How to switch between Reading Start/Pulse Start

1) Turn the power to the BLT-AY-61 or BLT-AY-71 off and remove the power cable from the
power outlet.
2) Remove the driver cable from the plug on the main unit.
3) Remove the cover of the main unit. Take care not to lose the screws.
4) Switch between reading start/pulse start using No. 2 of SW6 on the circuit board within the
main unit.
Pulse start is enabled with No. 2 ON, and Reading Start with No. 2 OFF.
5) After the settings have been changed, replace the cover of the main unit and attach with
the eight screws.
* Take care to prevent foreign particles entering the main unit while the cover is off.
No
Buzzer (ON -> buzzer beeps / OFF -> buzzer does not
1
beep
Switching between Reading Start/Pulse Start
2
ON -> Pulse Start / OFF -> Reading Start
- 13 -
Function
BLT-AY-61/BLT-AY-71
(with the cover removed)
(removing the eight
screws on each side)