Relationship Between Rpm And Torque; Blf-2000, Blf-5000 - HIOS BLT-AY-61 Operation Manual

■ Relationship between RPM and Torque

For the unloaded rotation speed, consider the value in the chart with the range of ± 10%.
Screwdriver
Speed Set-
ting
05 120 r.p.m
06 150 r.p.m
07 165 r.p.m
08 187 r.p.m
09 210 r.p.m
10 232 r.p.m
11 270 r.p.m
12 285 r.p.m
13 300 r.p.m
14 315 r.p.m
15 345 r.p.m
Screwdriver
Speed Set-
ting
20 690 r.p.m
21 720 r.p.m
22 750 r.p.m
23 780 r.p.m
24 810 r.p.m
25 825 r.p.m
26 870 r.p.m
27 975 r.p.m
28 975 r.p.m
29 975 r.p.m
30 975 r.p.m
* BLF-2000 includes two torque control springs. The silver spring accessory is used for high torque measure-
ment while the black spring attached to the main body is used for low torque measurement.
Please refer to the reference table of output torque in the "Instruction Manual" for the screwdriver for auto-
matic BLF brushless screwdriver.
(Cautions)
1. RPM may vary due to differences between forward rotation and reverse rotation. The reference
value is a rough guideline.
2. The listed RPMs were measured without load. In case Speed Setting is 27 or more, the actual
RPMs may differ from the values in the table according to the loads.
The torques were measured with our Torque meter (HP) and Fidaptor.
3. The values in above table may differ from the values observed in your environment. Please use
the above values as a rough guideline.
BLF-2000*
RPM Max Torque Min Torque
0.35 N・m
BLF-2000*
RPM Max Torque Min Torque
0.35 N・m
(BLF-2000 / BLF-5000)
RPM
115 r.p.m
135 r.p.m
150 r.p.m
180 r.p.m
195 r.p.m
0.03 N・m 210 r.p.m
240 r.p.m
255 r.p.m
285 r.p.m
300 r.p.m
320 r.p.m
RPM
660 r.p.m
690 r.p.m
720 r.p.m
750 r.p.m
780 r.p.m
0.03 N・m 810 r.p.m
840 r.p.m
940 r.p.m
940 r.p.m
940 r.p.m
940 r.p.m
- 19 -
BLF-5000
Max Torque Min Torque
0.6 N・m
0.8 N・m
0.3 N・m
1 N・m
BLF-5000
Max Torque Min Torque
1 N・m 0.3 N・m