Front Panel - HIOS BLT-AY-61 Operation Manual

■ Front Panel

2. Driver Connector
1. Main SW
A green LED will light up when the power is turned ON, and the operation display LEDs and
all segments of the value display will light up for 1 second.
2. Driver Connector
Attach the automatic BL driver cable.
3. Operation Display LEDs
The state of auxiliary inputs and outputs as well as the driver's operation can be monitored
with this LED array.
4. Setting Value Segment Display
Displays the settings for torque up rpm for Forward driver rotation / torque up rpm for re-
verse rotation / 2WS HIGH side rpm / 2WS LOW side rpm / 2WS HIGH side overtime / 2WS
LOW side overtime.
5. Function Button / UP Button / DOWN Button / ENT Button
Driver operating settings should be changed after a reset signal has been input. Other
inputs such as 2WS should also be disabled so that there are no LEDs lit up. Pressing the
Function Button will result in a short beeping buzzer sound. Holding the button down lon-
ger will result in a short beeping buzzer sound, and the operation display LED and setting
value segment display will turn on. Pressing the ENT button will switch between the opera-
tion display LED and setting value segment. The UP/DOWN buttons are used to change the
value of the settings.
After the settings are complete and the Function Button is pressed again, a short beep
buzzer will sound. On holding the button down longer, a two-second beeping buzzer will
sound one second from the start of pressing the button and the setting value segment dis-
play will turn off, indicating that settings are complete.
● Refer to page * for more information on how to change each setting.
3. Operation Display LED
- 10 -
4. Setting Value
Segment Display
5. Function Button
▲ UP Button
▼ DOWN Button
ENT Button