Display When The Power Is On With The Default Settings - HIOS BLT-AY-61 Operation Manual

Display When the Power is ON with the Default Settings

p.12
ＰＯＷＥＲ
ＤＲＩＶＥＲ
The BLT-AY-61 and BLT-AY-71 can be switched between 2WS HIGH (20 – 30) and 2WS LOW
(5 – 15) by turning 2WS ON / OFF. The bit can be rotated in reverse by turning REV (reverse
rotation input) ON / OFF.
The torque up number can be set regardless of whether the rotation is forward / reverse
or HIGH / LOW.
Change the number by following the steps in the MODE settings (pages 14 – 15).
In order to prevent the driver from rotating in the case of an accident, the built-in over-
time timer can also be set in the same way regardless of whether the rotation is forward /
reverse or HIGH / LOW.
Change the number by following the steps in the MODE settings (pages 14 – 15).
The factory settings are as follows.
● 2WS HIGH forward rotation impact number U1
● 2WS HIGH reverse rotation impact number
● 2WS HIGH setting speed
● 2WS HIGH overtime setting value t0 (approximately 42 minutes)
● 2WS LOW forward rotation impact number d1
● 2WS LOW reverse rotation impact number
● 2WS LOW setting speed
● 2WS LOW overtime setting value t0 (approximately 42 minutes)
● Overload protection function
* For the impact number setting, if you set U0 or d0, torque up does not happen and the impact is contin-
ued (setting without torque up).
(Note)
HIGH reverse rotation impact number or LOW reverse rotation impact number should be set at
U0 or d0 to use the driver for removing screws.
FOR OPE TUP FIN REV RES 2WS OVT
ENT
MODE
30
15
Front panel OL display
When the main SW is turned ON, the green
SW LED light up.
All operation LEDs and the setting value seg-
ment display will turn on for one second.
U0
d0
- 12 -