Mode Settings 2 - HIOS BLT-AY-61 Operation Manual

MODE Settings 2

(6) Forward rotation (2WS – LOW) torque up settings
Use ▲ / ▼ to change the settings (U0 to U4 and
d0 to d4)
Always check the changes with ENT. If changes
to other settings are not required, hold down the
Function Button to complete the setting process.
(7) Reverse rotation (2WS – LOW) torque up settings
Use ▲ / ▼ to change the settings (U0 to U4 and
d0 to d4)
Always check the changes with ENT. If changes
to other settings are not required, hold down the
Function Button to complete the setting process.
(8) Forward / reverse rotation (2WS – LOW) speed
settings
Use ▲ / ▼ to change the settings (05 to 15)
Always check the changes with ENT. If changes
to other settings are not required, hold down the
Function Button to complete the setting process.
(9) Forward / reverse rotation (2WS – LOW) over-
time settings
Use ▲ / ▼ to change the settings (t0 to t9)
Always check the changes with ENT. If changes
to other settings are not required, hold down the
Function Button to complete the setting process.
(10) Hold down the Function Button
"Beep (1 second) beeeep (2 seconds)"
All displays will turn off
(Note)
HIGH reverse rotation impact number or LOW reverse
rotation impact number should be set at U0 or d0 to
use the driver for removing screws.
- 15 -
※