Resetting The System; Default System Settings - Pioneer 7.1 VSX-AX2AV-S Operating Instructions Manual

Using other functions
10
The front panel display shows each of the following
settings for two seconds each:
Input source
Signal select
Video Select
Room 2 / REC SEL
2 When you're finished, press STATUS again to
switch off the display.

Resetting the system

Use this procedure to reset all the receiver's settings to
the factory default. Use the front panel controls to do this.
1 Switch the receiver into standby.
2 While holding down the front panel AV
PARAMETER button, press and hold
for about three seconds.
The display shows RESET?.
3 Press the front panel ENTER button.
The display shows RESET OK?.
4 Press SETUP to confirm.
OK appears in the display to indicate that the receiver
has been reset to the factory default settings.
• Note that all settings will be saved, even if the
receiver is unplugged.

Default system settings

Setting
HDMI Audio
Digital Video Conversion
Speakers
Surround Back System
Speaker System
Crossover
Bass Peak Level
X-Curve
THX Audio Setting
Inputs
See Input function default and possible settings on page 61.
66
En
Listening mode
Surround Back Processing
MCACC Position
Room 3
STANDBY/ON
Default
Amp
On
A
Normal (SBch)
Front SMALL
Center SMALL
Surr. SMALL
SB SMALLx2
SW YES
80 Hz
OFF
OFF
0.0–0.3m
Setting
Multi Room
Room 2 Volume Type
Room 2 IR Receiver Type
Room 2 Volume
SR+
SR+ Control On/Off
SR+ Volume Control On/Off
Monitor Out
DSP
MCACC Position Memory
Surround back channel
Processing
Phase Control
Sound Delay
Dual Mono
DRC
SACD Gain
Digital Safety
Effect Level 7 ch Stereo
Other modes
2PL II Music Options Center Width
Dimension
Panorama
Neo:6 Options Center Image
All Inputs Listening Mode (2 ch) AUTO SURROUND
Listening Mode (x ch) AUTO SURROUND
Listening Mode (HP)
See also Setting the AV options on page 63 for other default DSP
settings.
MCACC
Channel level (M1–M6)
Speaker Distance (M1–M6)
Standing Wave Standing Wave On/
(M1–M6) Off
ATT
SWch Wide Trim
EQ Data (M1–M6) All channels/bands
EQ Wide Trim (M1–M6)
Default
Variable
SETTING 1
-60
OFF
OFF
OFF
M1: MEMORY 1
ON
On
0 frame
CH1
OFF
0 dB
OFF
90
50
3
0
OFF
3
STEREO
0 dB
3.0 m
ON
0 dB
0.0
0 dB
0.0 dB