Resetting The System; Default System Settings - Pioneer VSX-924-S Operating Instructions Manual

09

Resetting the system

Use this procedure to reset all the receiver's settings to the factory default. Use the front panel controls to do this.
Set MULTI-ZONE to MULTI ZONE OFF.
! Disconnect the iPod and USB memory device from the receiver beforehand.
! Set the Control with HDMI to OFF (see HDMI Setup
1 Switch the receiver into standby.
2 While holding down ENTER on the front panel, press u STANDBY/ON.
The display shows RESET c NO d.
3 Select 'RESET' using PRESET k/l, then press ENTER on the front panel.
The display shows RESET? OK.
4 Press ENTER to confirm.
OK appears in the display to indicate that the receiver has been reset to the factory default settings.
! Note that all settings will be saved, even if the receiver is unplugged.

Default system settings

Setting
Digital Video Converter
SPEAKERS
Speaker System
Front
Center
FH/FW
Speaker Setting
Surr
SB
SW
Surround Position
Crossover
X-Curve
DIMMER
Inputs
See Input function default and possible settings on page 39
Input Volume Absorber All Inputs
HDMI
HDMI Audio
Control
Control Mode
ARC (Audio Return Channel)
PQLS
Standby Through
DSP
Power On Level
Volume Limit
Mute Level
on page 63 ).
Default
OFF
SB/FH ON
Normal(SB/FH)
SMALL
SMALL
SMALL
SMALL
SMALLx2
YES
ON SIDE
80Hz
OFF
Medium bright
.
0dB
AMP
OFF
--- (OFF)
--- (OFF)
--- (AUTO)
OFF
LAST
OFF
FULL
Setting
Phase Control
iPod/USB, INTERNET RADIO, PANDORA
(Australian model only), MEDIA SERVER,
Auto Sound Retriever
FAVORITES, BT AUDIO input function
Other input functions
Sound Delay
Dual Mono
DRC
LFE Attenuate
Auto delay
Digital Safety
Effect Level ALC (Auto Level Control)
Center Width
PL II Music Options Dimension
Panorama
Neo:X Options Center Gain
Height Gain
PL IIz Options
Listening Mode (2 ch/multi ch)
All Inputs
Listening Mode (Headphones)
See also Setting the Audio options on page 67 for other default DSP settings.
MCACC
MCACC Position Memory
Channel Level (M1 to M6)
Speaker Distance (M1 to M6)
ATT of all channels/filters
Standing Wave (M1 to M6)
SWch Wide Trim
All channels/bands
EQ Data (M1 to M6)
EQ Wide Trim
Network
Network Standby
DHCP
74
Using other functions
Default
ON
ON
OFF
0 ms
CH1
AUTO
0dB
OFF
OFF
50
3
0
OFF
Neo:X CINEMA: 1.0
Neo:X MUSIC: 0.3
Neo:X GAME: 1.0
MID
AUTO SURROUND
STEREO
M1. MEMORY 1
0.0 dB
3.00 m
0.0 dB
0.0 dB
0.0 dB
0.0 dB
OFF
ON