Siemens M56 User Manual page 115

M56 Barracuda long, am english, A31008-H6350-A40-1-4A19 (28. July 2003,
Control codes (DTMF)
Send control code
You can, for example, enter control
codes (numbers) for remote access
to an automatic answering machine
while another connection exists.
These entries are transmitted
directly as DTMF codes (control
codes).
y menu§ Open call menu.
Send DTMF Select.
Use the Phonebook
Store phone numbers and control
codes (DTMF codes) in the Phone-
book/Addressbook in the same way
as a normal entry.
Enter phone number.
Press until a "+" appears in
the display (wait for the
connection to be estab-
lished).
Enter DTMF codes (num-
bers).
If necessary, wait again
for three seconds at a
time for the receiver to
process the entries safely.
Enter a name.
§Save§ Press.
You may also store just the
DTMF codes (numbers) and then
send them during the call.
Notes A-Z
Copy protection
Applications may be copy-protected.
Applications protected in this way
may only be run on devices for
which they are intended. It is, how-
ever, always possible to create a
backup copy of these applications on
your PC using the "Siemens Data
Suite" (p. 122).
CSD connection
(Circuit Switched Data)
Data is transferred via a data connec-
tion to a dial-in point pre-set by your
network operator or service pro-
vider. This connection can be used
for exchanging data, such as, for
example, Internet access, or for
downloading games and applica-
tions as well as for using WAP ser-
vices.
As long as you are using this connec-
tion for downloading applications
from the Internet or using services,
you must pay connection fees
according to your network operator's
or service provider's table of charges.
115