Table of Contents
Advertisement
Ventilation
Ventilation to the room that houses the fi re must meet the requirements of NZS5261.
Fireplace cavity and chimney inspection
Real Fires are designed for installation into an existing masonry fi replace and chimney. Prior to installation the
fi replace should be measured and a suitable size Real Fire selected. In most situations the fi replace will require
masonry alteration to accommodate the fi rebox. See installation drawing.
The chimney will need to be inspected for suitability and checked for draw. Ensure it complies with a minimum
height of 2.4 Metres. The top of the chimney is a minimum vertical clearance of 900mm from the roofl ine and 2
Metre horizontal clearance from any roofl ine or any other part of the building. See cowl clearance drawing.
The chimney should be swept prior to installation.
New Masonry Block Chimney
Installation of a Real Fire into a new masonry chimney may require installation with an insulation kit and fl ue kit.
This will also involve leaving the fi replace opening 1200mm high to allow installation. The method of installation is
as per timber frame installations. Please consult Real Fires in this situation for advice prior to installation.
Hearth
A non combustible Hearth must be provided in front of the Real Fire unless the fl ooring in front of the fi re is non
combustible. The minimum size is 300mm out from the fi re and 150mm each side wider than the fi re.
Height of re from oor
It is important to confi rm the height the fi re is going to be installed above the fl oor. This is usually the hearth
height. For example if the hearth is going to be 100mm high then the base of the fi replace cavity usually needs to
be the same height. (note- some elevated installations specify the fi re higher than the hearth). It is important that
the base of the cavity is plastered smooth and level.
Model 700
Installation Into Existing Masonry Fireplace
realfi res.co.nz
Advertisement
Table of Contents
