Table of Contents
Advertisement
Burner Gas pressure
Check burner gas pressure from the test point on the burner supply pipe on the Natural Gas Model and on the
injector elbow on the L.P.G. model.
See appliance data badge for pressure settings
Adjust the pressure at the regulator if required.
Check the re is operating correctly and test for spillage of combustion products
Optional Fan
If a fan has been selected with the fi re, it will already be fi tted in the fi rebox at the factory. It is controlled by a wall
switch, which should be fi tted by an electrician. There is no switching on the fi re and the wall switch is not suppled
by Real Fires.
Fitting Trim to rebox
Fit the Stainless Steel or Black trim to the fi rebox. The trim brackets are designed to hang over the fl ange on the
front of the fi rebox. The fl ange has provision to be moved slightly in or out to allow the bracket to fi t. The fl ange
on each side of the fi rebox has raised square near the base of the fi re. The Velcro pad is fi xed to this by removing
the backing from one side one side of the pad and pushing fi rmly in place. Then remove the backing from the
other side. Repeat on opposite side. Hang trim on brackets and check for level then push fi rmly onto Velcro pad.
Instruct User
Once the installation is complete, instruct the user on the operation of the fi re and complete commissioning
details in the Real Fires user manual.
ALL INSTALLATIONS MUST BE CERTIFIED
realfi res.co.nz
Advertisement
Table of Contents
