Table of Contents
Advertisement
Installation instructions - Firebox
Once the fi replace cavity has been prepared and the gas supply pipe is positioned at the rear right hand side.
The fi rebox can be installed.
Note - Electrical options
The fi rebox will have two electrical leads from the rear of the fi rebox. All fi reboxes are pre wired for electrical
options, Fan and Electric On/O . The leads are approximately 1.2 metre long, they are intended to be connected
by an electrician to a wall switch for the user near the fi replace. The lead(s) will need to be left accessible after the
fi rebox is installed. This will mean drilling through the masonry cavity base, side, or rear as appropriate. Feed the
lead(s) through as the fi rebox is positioned into the masonry cavity. The leads(s) must be positioned low and not
touching the back of the fi rebox.
Installation instructions - Firebox continued
As the fi re is positioned into the masonry cavity, the 10mm copper gas pipe is pushed through the hole at the
right hand rear of the fi rebox (RH from the front of the fi re). This pipe is to be connected to the burner after
fi rebox installation. Apply high temperature sealant to the back of the fl ange around the front of the fi rebox.
Push the fi rebox into position carefully and ensure a good seal is made between the fl ange and the masonry. If
required the fi rebox can be secured in place by drilling the fl ange and securing to the masonry with screws.
Installation instructions - Cowl
A cowl spigot plate is fi xed to the chimney by masonry screws or mortar. The cowl is then pushed fi rmly onto the spigot.
realfi res.co.nz
Advertisement
Table of Contents
