Kobalt SGY-AIR185 Manual page 12

ASSEMBLY INSTRUCTIONS
4. If necessary for a longer reach, mount an
extension bar (not included) onto the
anvil (B) until it clicks into place, then
mount the socket on the adapter.
5. Place 2 – 3 drops of air tool oil
(not included) into the male air plug before
each use, as shown in Fig. 5.
NOTE Proper lubrication is EXTREMELY
important to assure proper tool performance
and avoid tool damage. ALWAYS lubricate
the tool before each use if not using an
in-line oiler.
6. Connect the air supply hose (not included)
to the male air plug, making sure it is
completely seated and secure. Set the
working pressure at 90 PSI for best tool
performance.
NOTE
To operate correctly, this tool requires
airflow of at least 5.3 cubic feet per minute
(SCFM) at 90 pounds per square inch (PSI)
at the tool.
4
5
6
12
B
kobalttools.com