Table of Contents
Advertisement
WattStation Pedestal Installation Manual
S S t t e e p p 1 1 8 8 : : Connect L1 and L2 to the
PDB – Power Distribution Block
and ground wire to the ground
lug shown in Figure 10.
S S t t e e p p 1 1 9 9 : : The CAT5 cable is connected to the
Ethernet port. It is recommended to run 2
CAT5 cables if there are future or current
plans to support communication daisy
chaining of GE WattStation Pedestals
C C a a b b l l e e r r e e e e l l
WARNING
1.
Cable should not be extended beyond the red indicator line at the end of the cable.
may cause the cable reel to bind, prohibiting
2.
If
cable becomes bound due to over-extension, the following steps must be followed to retract the cable before
returning to normal operation
[2.1] Turn off the power
[2.2] Open the access door
[2.3]
Manually
[ [ 2 2 . . 4 4 ] ] P P o o w w e e r r u u p p t t h h e e u u n n i i t t
1 1 5 5
rotate the cable
reel
in
a
a a s s n n o o r r m m a a l l , , u u n n i i t t c c a a n n b b e e r r e e t t u u r r n n e e d d t t o o n n o o r r m m a a l l o o p p e e r r a a t t i i o o n n
G G E E E E n n e e r r g g y y
F F i i g g u u r r e e - - 1 1 0 0
retraction.
counter-clockwise direction
F F i i g g u u r r e e - - 1 1 1 1
Pulling beyond
until the cable is fully retracted.
© © 2 2 0 0 1 1 2 2 G G E E C C o o m m p p a a n n y y A A l l l l R R i i g g h h t t s s R R e e s s e e r r v v e e d d
this indicator
Advertisement
Table of Contents
