Advertisement
most inside, then release is ok.
Pop up: Use finger to press SIM card or T-Flash card, then release, to get the card out of the
system.
2. How to install Door/Window Sensor (Fig 3)
A. Door sensor is consisted of two parts: transmitter part and magnetic part .You can fix them
with screws or adhesive.You need to check the LED side of transmitter part against the
magnetic part . The maximum limit is 15mm between them.
B. If you use the configured adhesive to install the door/window sensor, please make sure the
installation position flat and clean. If you install it on the wooden material, please install with
setscrews.
C. If the door/window sensor's low power indication light flashes or the transmission distance
is nearer than before, please change the battery (12V, 23A).
Open from right
Double open
Open from left
Slide window
1
2
3
4
3. How to install Motion Detector (PIR)
Firstly peel off the cover, and then fill with the battery. It must be installed 1.6cm off from the
wall, 1.5m to 2.5m high from the ground and face the monitoring area, inner house to avoid
the direct sun light.
Wide-angle motion detector: vertical 55°, horizontal 110°, distance 8m.
Curtain motion detector: vertical 99°, horizontal 20cm thickness, distance 8m.
4. How to install Gas Leakage Detector
Install it with the distance of 0-4m from the gas source.
B. Inner 0.3m high from the ground if Liquid petroleum gas; inner 0.3m from the ceiling if coal
and natural gas.
C, It takes 3 minutes for preparing work. The red light will be flashing in preparing.
D, User should check and clear it to ensure its effect in normal days.
5. How to install Smoke Detector
Fill the 9V battery firstly, press Test button over 3 seconds, or flow the smoke into the
detectors, it means it works normally when hear "beep" sound. Please install it on the top of
wall or ceiling and do not install it near the door or window.
6
Advertisement
