Advertisement
If user name and password are in blank, so it don't need to fill in. Only send:
password+APN+"APN"
E.g China mobile APN is CMWAP, user name: in blank, password: in blank
Sending SMS to 3G alarm main host: 1234APNCMWAP
After setting successful, it will feedback SMS: Access Point Name Setting successfully
E.g APN is WAP, user name: ABC, password: 123
Sending SMS: 1234APNWAP,ABC,123
2) Setting MMS centre address(MMSC URL)
Sending SMS to 3G main host: password+URL+"MMSC url"
E.g China mobile MMSC URL is http://mmsc.monternet.com Sending SMS to 3G main
host: 1234URLhttp://mmsc.monternet.com
If setting successful, it will feedback SMS: MMS Center URL Setting successfully
3) Setting MMS Proxy
Sending SMS to 3G main host: password+PROXY+"IP"+,+"PORT"
E.g China mobile MMS Proxy is 10.0.0.172:80
1234PROXY10.0.0.172,80
If setting successful, it will feedback SMS: MMS Proxy Setting successfully
1. Why I didn't receive video talking alarm?
A. When you set video talking alarm phone numbers, you forgot to add 3* in the correct
command "#(1 ～ 6 )*3*phone number# ", then you only can have audio talking function.
B. Wrong video talking alarm number or your number is not in the 3G service area.
C. The system haven't enter 3G network. Please look at the rear of the camera, if the red
STATE light flicker every 5s, it indicate 3G signal is ok; if not, no 3G signal.
D. The SIM card you inserted is not a 3G WCDMA SIM card.
2. Why remotely dial in and indicate:"Wrong password, please input again."?
(1) please confirm whether the password you input is correct. You can alter it according the
altering command.
(2) please confirm every number of the password you are inputting, you can hear the main
host sending out the confirming voice"beep". If not, please input the number one more time.
3. Why it can't view the live video when I call in remotely?
Please confirm whether you use the visual phone to dial. If it is just the voice call, you can't
view the live video. Please use the visual phone to dial to the main panel.
4. Why i can't receive MMS although I have preset the MMS phone number?
The factory setting defaults parameter of MMS is China Union. If you use other communication
operator, please refer to the MMS network parameter setting before using.
Chapter Seven: FAQ:
Sending SMS to 3G main host:
23
Advertisement
